03-11-2014, 02:22 PM
Abstracts: Now a days, time is very precise than cost. Our project is on the basis of design an instrument which is used to open nuts of four wheeler vehicle. By survey in garages , we feel that , there is much time spend to open four nuts. If there is more than four nuts like in trucks, tractors than this problem is very serious. So, we make spanner which open four nuts at a time. So, time for open nuts is save. There are very problem to make this element. Because, due to non-flexibility it is used for some specific vehicle. We choose HYUNDAI-i 10 vehicle to open the nuts. This is limitation that it is not used for all vehicle, but only one specified vehicle. Some modification necessary to resolve this problem. But our project work is only design and development of gang spanner. For design, we need some procedure and force analysis also required. To design all elements of gang spanner we use AUTO-CAD software. After this procedures we develop gang spanner. Due to single production our project cost is high. But in mass production it is feasible.