29-05-2013, 02:03 PM
DRAFTING TOOLS FOR ENGINEERING DRAWING
DRAFTING TOOLS.pdf (Size: 237.96 KB / Downloads: 28)
Engineering drawings are defined as those drawings that communicate the
requirements for the manufacture of the end-product items, their assembly, and their
installation in the end product.
Title Block and Revision Block
Title blocks and revision blocks shall be prepared and completed as follows:
The Title block of single-sheet drawings, first sheets of multisheet drawings, and
revision blocks shall appear as shown in either Figure 2a on page 5 (dimensional
system/inches) or Figure 2b on page 6 (dimensional system/millimeters). The
information required in the Title block shall be as specified or referenced by items 1
through 28, below. The Title block of continuation sheets for multisheet drawings shall
contain information listed in items 1, 2, and 4 through 11.