16-01-2013, 04:30 PM
FLASH CONTROLLER PROGRAMMING
FLASH CONTROLLER PROGRAMMING.doc (Size: 44.5 KB / Downloads: 20)
Introduction
The LABTOOL-48UXP is a high performance intelligent PC-based universal programmer that works through your PCs parallel port. It features 48-pin ZIF sockets, supports all kind of programmer chip in the market which include CPLD, EPROM,
EEPOM, Serial EEPROM, Flash memory and MCU, extremely high throughput, 5V and 3V chip support in both Vcc and I/O,lower voltage chip (for example 1.8V Vcc and I/O support) also possible through special adapter, device insertion and continuity checks, all within a PC-based design. Device updates are disseminated through software, giving our
customers quicker and more flexible access to new chip support.
Features
Universal adapter below 48 pin
The LABTOOL-48UXP is designed to meet you future needs in high density Flash chips. Using the resources of your PC, it supports 32K bit up to over G bit memory chips without upgrading its hardware. The LABTOOL-48UXP also has a universal adapter that accommodates 48-pin TSOP, 44-pin PLCC, 40-pin TSOP, and 32-pin TSOP that support all the chip in same adapter which eliminates the need to buy multiple
adapters and saves you money.
Unbeatable speed
The LABTOOL-48UXP′s on-board intelligence reduces system overhead to a minimum. It can program Flash chips within 2.5 second per M bit (for example, AMD29DL323 can be programmed by LABTOOL-48UXP within 80 seconds). An
experienced operator can program thousands of high-density 3 chips per day.
Device-insertion and continuity checks – No mistakes!
The LABTOOL-48UXP performs device-insertion and continuity checks before programming each device. It can detect poor pin contact, upside-down device insertion, incorrect position, and pin number mismatch. This function protects your pocketbook by preventing expensive chip damage caused by operator mistake.
Auto-sensing and self-programming
The LABTOOL-48UXP has implemented patented technology to meet mass-production requirements. When a chip insert into the ZIF socket, the LABTOOL-48UXP will start to program the chip automatically, operator just follow the LED to remove
the chip and insert the chip without need to press any key.
Project file “Save and Load”
You can save the program configuration project file that contains the device selection, the buffer data, and all of the program setup options. This file can be recalled at any time for future use without having to go through the setup procedure again. This allows you to pass your design file to the production department without mistakes.