27-08-2014, 12:13 PM
ESCORT GOETZE (I) LIMITED, BAHADURGARH was set up in 1954 by Mr. H.P.Nanda with the collaboration of M/S GOETZE WERKE, GERMANY, which started its production of Piston Rings for automobile industry in 1957. In October 2006 name changed “Goetze (India) Limited” to “FEDERAL-MOGUL GOETZE (INDIA) LIMITED” because majority stake holding acquisition by Federal-Mogul Corporation. Federal-Mogul Goetze (India) Limited�is the largest manufacturer�of pistons and piston rings in India Pistons are varying from 30mm to 300mm diameter.
PRODUCTS OF PATIALA PLANT
PISTON RINGS PISTON PINS SHOPS OF PATIALA PLANT PISTON FOUNDRY PISTON MACHINE SHOP RING FOUNDRY SHOP RING MACHINE SHOP TOOL ROOM PIN PLANT TOOL ROOM Tool room is a repairing and tool unit at Goetze India Limited, Bahadurgarh. In this shop special purpose dedicated machines are used for the processing of jobs like production jobs, maintainance job and cutting tools. It is that place which is capable of making same type of machine. SECTIONS IN TOOL ROOM GRINDING SECTION TURNING SECTION TOOL CUTTING AND GRINDING SECTION DIE SECTION MILLING SECTION CNC SECTION OPERATION IN TOOL ROOM FACING UNDER CUTTING GROOVING KNURLING FINISH TURNING CHAMFERING DRILLING BORING GRINDING HOBBING SHAPING INTRODUCTION TO PROJECT To Decrease The Cost Reduction And Time In Making The Model Plates. INTRODUCTION TO THE MODEL PLATE The Model Plate Is Used For Formation Of Impression Of Rings On Sand Blank Which Is Used For Casting Of Rings. The Model Plate Is Used In The Ring Foundry Shop Where Rings Are Casted Of Different Sizes According To The Requirement Of The Company. The Rings Are Formed By Pouring Molten Metal In The Impression Formed Using Model Plate. MODEL PLATE DIFFERENT COMPONENTS RISER RUNNER RINGS FEEDER RISER The Riser Is To Be Placed In The Front Of The Feeder .The Riser Is Used To Control The Shrinkage Of The Molten Metal. RUNNER The Runner Is The Feeding System Of The Molten Metal By Which The Molten Metal Is Passed To The Different Portion Of The Blank Where Ever The Molten Metal Is Required. RINGS Rings On The Plate Are Made Up Of Brass Material For The Impression Of Rings. The Rings Are Attached To The Model Plate By The Use Of Screws And The Adhesive Material. IMPROVEMENT IN MODEL PLATES Area Of Improvement Adhesion Of Model Rings And Aluminum Base Plate Background – Earlier Screw Were Used To Join Rings And Model Plates The Model Rings Were Joined With Special Adhesive Solution ADVANTAGES 1. Lead Time For Fitting Model Plate Fitting Reduced From 36 Hours To 20 Hours.2. Drilling Operation On Model Plate For Rings Saved .3. Lead Time For Repairing Plates Also Reduced .4. Aluminum Base Plate Can Be Re Used