24-07-2012, 05:11 PM
Two-way radio
Two-way radio.docx (Size: 92.02 KB / Downloads: 28)
INTRODUCTION
A two-way radio is a radio that can both transmit and receive (a transceiver), unlike a broadcast receiver which only receives content. A two-way radio (transceiver) allows the operator to have a conversation with other similar radios operating on the same radio frequency (channel). Two-way radios are available in mobile, stationary base and hand-held portable configurations. Hand-held radios are often called walkie-talkies or handie-talkies.
Two-way radio systems usually operate in a half-duplex mode; that is, the operator can talk, or he can listen, but not at the same time. A push-to-talk or Press To Transmit button activates the transmitter; when it is released the receiver is active. A mobile phone or cellular telephone is an example of a two-way radio that both transmits and receives at the same time (called full-duplex mode). It uses two different radio frequencies (channels) to carry the two directions of the conversation simultaneously.
History
Installation of receivers and transmitters at the same fixed location allowed exchange of messages wirelessly. As early as 1907, two-way telegraphy traffic across the Atlantic Ocean was commercially available. By 1912 commercial and military ships carried both transmitters and receivers, allowing two-way communication in close to real-time with a ship that was out of sight of land.
The first truly mobile two-way radio was developed in Australia in 1923 by Senior Constable Frederick William Downie of the Victorian Police. The Victoria Police were the first in the world to use wireless communication in cars, putting an end to the inefficient status reports via public telephone boxes which had been used until that time. The first sets took up the entire back seat of the Lancia patrol cars.[1]
As radio equipment became more powerful, compact, and easier to use, smaller vehicles had two-way radio communication equipment installed. Installation of radio equipment in aircraft allowed scouts to report back observations in real-time, not requiring the pilot to drop messages to troops on the ground below or to land and make a personal report.
Scanning in conventional radios
Some conventional radios scan more than one channel. That is, the receiver searches more than one channel for a valid transmission. A valid transmission may be a radio channel with any signal or a combination of a radio channel with a specific CTCSS (or Selective calling) code.
There are a wide variety of scan configurations which vary from one system to another. Some radios have scan features that receive the primary selected channel at full volume and other channels in a scan list at reduced volume. This helps the user distinguish between the primary channel and others without looking at the radio control panel.
Talk-back on scan
Some conventional radios use, or have an option for, a talk-back-on-scan function. If the user transmits when the radio is in a scan mode, it may transmit on the last channel received instead of the selected channel. This may allow users of multi-channel radios to reply to the last message without looking at the radio to see which channel it was on. Without this feature, the user would have to use the channel selector to switch to the channel where the last message occurred. (This option can cause confusion and users must be trained to understand this feature.)