24-07-2012, 04:39 PM
MPFI and Emission control system
MPFI and Emission control system.pdf (Size: 266.65 KB / Downloads: 29)
INTRODUCTION
Petrol vehicles uses device called carburetor for supplying the air fuel mixture in correct ratio to cylinders in all rpm ranges. due to construction of the carburetor is relatively simple, it has been used almost exclusively on gasoline engines in the past. However in response to recent demands for cleaner exhaust emission, more economical fuel consumption, improved drivability, etc., the carburetor now must be equipped with various compensating devices, making it more complex system.
MAIN COMPONENTS OF MPFI SYSTEM This system has four major components they are:
a) Air intake system
b) Fuel delivery system
c) Electronic control system
Air intake system .
The air (corresponding to the throttle valve opening) is filtered by the air cleaner, passes through the throttle body, and is distributed by the intake manifold and finally drawn into each combustion chamber. When the lAC valve is opened according to the signal from ECM, the air bypasses the1hrottle valve through bypass passage and is finally drawn into the intake manifold
Fuel delivery system
The fuel in the fuel tank is pumped up by the fuel pump, filtered by fuel filter and fed under pressure to each injector through the delivery 'pipe. As the fuel pressure applied to the injector is always kept a certain amount higher than the pressure in the intake manifold by the fuel pressure regulator, the fuel is injected into the intake port of the cylinder head when the injector opens according to the injection signal form ECM. The fuel relieved by the fuel pressure regulator return through the fuel return to the fuel tank.
Fuel injection control system
The electronic fuel injection system supplies the combustion chambers with air/fuel mixture of optimized ratio under widely varying driving conditions. It uses the sequential multi-port fuel injection system, which injects fuel into each intake port of the cylinder head. In this system ECM controls the time and timing of the fuel injection from the fuel injector into the cylinder head intake port according to the signals from the various sensors so that suitable air/fuel mixture is supplied to the engine in each driving condition.
Fuel pump control system
ECM controls ON/OFF operation of the fuel pump by turning it ON, the fuel pump relay under any of the conditions. For two seconds after ignition switch ON. While cranking engine (while engine start signal is inputted to ECM). While crankshaft position sensor or camshaft - position sensor signal is inputted to ECM.