18-03-2014, 02:15 PM
Maximo Navigation Bar
Navigation Bar.ppt (Size: 1.62 MB / Downloads: 40)
Maximo uses the Navigation Bar to identify the current application, display messages, and display links that let you maneuver among Maximo applications
Application icon and name
Message area
Navigation Links
Bulletins
Go To
Reports
Start Center
Profile
Sign Out, Return, Return with Value, Help
Basic Searches
Using Saved Queries to Search
Using the Find Field to Search
Using the Table Filter to Refine Search Results
Special Characters and Maximo
ampersand (&)
hyphen (-)
pipe (|)
semicolon (
tilde (~)
Maximo Wildcard Characters
Use the underscore (_)
Use the percent sign (%)
The Assets Module
The Asset Module consists of the following applications.
Assets:Used to create and store asset numbers and corresponding information, such as parent, location,vendor, up/down status, and maintenance costs for each asset.
Condition Monitoring: Used to define measurement points for assets or locations, and to specify alarm limits and associated work to be performed after reaching those limits.
Failure Codes:Used to define failure codes and define the Problem,Cause, Remedy hierarchy.
Locations:Used to create location records and track assets that exist at the location. Also used to build hierarchical or networked systems.
Meters:Used to define meters that can be used to track asset and location performance.
Meter Groups:Used to create groups of meters that can then be applied to assets or locations at the same time.
Work Order and Asset
Work orders are written against a piece of Asset(Equipment) or a location. When work orders are performed and completed, Maximo Enterprise Asset Management sends the total cost of work to the Asset module.
Failure codes defined in the Asset module can be used lo identify the problem, cause, and remedy on the work order
Entering Assets and Asset Detail Records
Will work on this equipment require taking down other assets ?
Are there pending work orders against the asset, or against other assets at the location, that can be done now?
Will work at this location affect other locations?
Are there pending work orders against the location itself?
Asset Status
The Status field can indicate either when an asset is:
• Not Ready Default status for new asset records. Asset records can be created before assets have been received, installed, configured, inspected, or otherwise approved for their intended use.
• Decommissioned Asset has been retired from service and moved to scrap or salvage.
• Operating Asset has been received, installed, configured, inspected, or otherwise approved for use or operation.
Additional points on asset status:
• Initial entry of an asset record into Maximo Enterprise Asset Management defaults to a Not Ready status.
• When an asset has the status. Decommissioned, it cannot be viewed with other applications, such as Work Order Tracking, but can only be viewed with the Assets application.