05-01-2016, 03:23 PM
Abstract:
We present the design of a field programmable gate array (FPGA) based optical orthogonal frequency division multiplexing (OFDM) transmitter operating at 21.4 GS/s and an experimental assessment of its performance in a directly-detected 8.34 Gbit/s QPSK-OFDM configuration over 1600 km of uncompensated standard fiber. We also discuss the suitability of OFDM technology for low-cost, low-power optical interconnects.
Introduction
Optical orthogonal frequency division multiplexing (OFDM) is a promising technology to enable ultra-high capacity networks. Recently, real-time implementations of optical OFDM transmitters [1, 2], receivers [3] and transceivers [4] have been demonstrated using field programmable gate arrays (FPGA). In this paper we describe the design of an FPGA-based OFDM transmitter operating at 21.4 GS/s and investigate the suitability of such technology for low-cost, low-power optical interconnects.
Transmitter design & performance
The top level design of the optical OFDM transmitter, which consists of a DSP block, an analog section and an optical frontend, is shown in figure 1 (a). The DSP was performed on a Xilinx Virtex-4 (4VFX100) FPGA operating at a clock frequency of 167.2 MHz. The FPGA board was interfaced to a 21.4 GS/s, 4-bit resolution DAC using sixteen serial lines operating at 5.35 Gbit/s as described in [5]. The DSP block functions are illustrated in Fig. 1 (b). A 215 bit sequence DeBruijn pattern and synchronization overhead were stored in a read only memory (ROM) on the FPGA and a block of N = 50 bits was read out each clock cycle and passed on to the QPSK modulator. The latter modulated the input bits to form 25 complex 10-bit QPSK codes. These were then fed to the 128-point, 10-bit IFFT core to generate single sideband OFDM signals with 1.28 oversampling. In this work, only the real output of the IFFT was utilized and sent to the clipping module to be converted into a 4-bit word compatible with the deployed DAC. The 10-bit resolution IFFT core was chosen because it offers the best trade off between system performance (signal quality) and DSP complexity [6]. It utilized a mix of radix 8 and radix 16 algorithms and was generated using the Spiral hardware generation tool to support a throughput of one transform per cycle (167.2 MHz)
First the output of the DAC was connected to a 50 GS/s real-time sampling oscilloscope to evaluate the analog quality of the OFDM signals (electrical back-to-back), using error vector magnitude (EVM). Figure 1 © shows the EVM and equivalent BER of each sub-channel (hollow circles). Due to the DAC frequency roll-off, the EVM increases with increasing sub-channel frequency. A similar trend can be noticed in Fig.1 © for the optical back-to-back configuration (using direct-detection) where a 1 dB penalty can be observed (triangles). The OFDM signal was then transmitted, by means of a recirculating loop, over 1600 km of uncompensated standard fiber with -3 dBm launch power. No cyclic prefix was implemented and dispersion equalization was performed offline at the receiver. The measured overall BER was 2×10-4 and EVM = -11.7 dB.