24-06-2013, 03:45 PM
Next Generation 2-Stroke Engine
Next Generation 2-Stroke.docx (Size: 164.42 KB / Downloads: 71)
ABSTRACT
Are two stroke motorbikes poised for a comeback? With new development, they can compete with four stroke in emission cleanliness, full economy & rideability while retaining power, size & weight advantages.
Now days this is the age of four-stroke engme. Because of its various advantageous like mileage, power and one of the greatest advantage is that it's emission.
And therefore it is certify that it is cleanliness and made very low pollution. Because of this the two stroke engine is left out from the market. All the giant companies turn towards four stroke engines.
At this stage were there is no demand for two stroke engine, because of the concentrated effort of an Australian base Orbital Engine Company take a giant leap, they took back two stroke engine technology, having advantageous over four stroke engine in all respect. And which is tie with greatest automobile companies like Peugot , Aprila and Bajaj also. This technology not restricted only for two-wheeler but also use in four-wheeler like BMW& Ford also.
INTRODUCTION
When two-stroke motorbikes comes to off road motor cross racing.
Two stroke-powered bikes have always taken the lead. But its harmful emission forced the Environmental Protection Agency to ban them from rallies in America. Finally after a long wait two stroke returning to the circuit with a total redesign of engine, its fuel injection system, & working. This was possible due to the concentrated effort of an Australian organization, the Orbital Engine Company that pioneered the development of direct in cylinder fuel injection system, which reduces emission level but also increases power. In addition the redesign of the combustion chamber & valve mechanism by Honda & Bimota has enabled them to run the engine without spark plugs! In basic two stroke working cycle, fuel enter the cylinder through the intake port from one side of the cylinder & pushes spent exhaust gases out of the exhaust port on the opposite cylinder wall at the same time. This causes the fuel to mix with the exhaust gases. Some amount of exhaust gas invariably remains in the cylinder as the fresh charge comes in. When spark plug ignites the fuel mixture, some fuel is isolated from the flame by the exhaust gases still in the cylinder Goes not bum.
CONVENTIONAL TWO-STROKE ENGINE
The air or charge is sucked through spring loaded inlet valve when the pressure in the crankcase reduces due to upward motion of the piston during compression stroke. After the compression stroke, ignition & expansion takes place in the usual way. During the expansion stroke the air in the crankcase is compressed. Near the end of expansion stroke piston uncover the exhaust port
And the cylinder pressure drops to atmospheric as the combustion products leave the cylinder. Further motion of the piston uncovers the transfer port, permitting the slightly compressed air or mixture in the crankcase to enter engine cylinder. This causes the fuel to mix with the exhaust gases. Some amount of exhaust gas invariably remains in the cylinder as the fresh charge comes in. When spark plug ignites the fuel mixture, some fuel is isolated from the flame by the exhaust gases still in the cylinder & does not bum. For this some provision is done, the top of Next Generation 2-Stroke Engine the piston usually has a projection to deflect the fresh air to sweep up to top of the cylinder before flowing to the exhaust port. This serves the double purpose of scavenging the upper part of the cylinder of combustion product & preventing the fresh charge from flowing directly to the exhaust ports. The same objective can be achieved without piston deflector by proper shaping of the transfer port. During the upward motion of the piston from BDC, the transfer ports &then the exhaust port close & compression of the charge begins &cycle is repeated.
SCAVENGING PROCESS: -
At the end of expansion stroke, the combustion chamber of the two stroke engine is left full of products of combustion. This is because, there is no exhaust stroke is available to clear the cylinder of burnt gases. The process of clearing the cylinder after the expansion stroke is called scavengmg.
AIR ASSISTED DIRECT INJECTION SYSTEM (ASDI)
Developed by Orbital leading international developer of engine technologies direct in cylinder fuel injection & lean bum system for enhanced fuel economy & lower emission. This technology exceeds the EP A 2006 emission standards & offers 40% fuel efficiency over conventional two stroke. Different automotive companies have licensed & experimented with Orbital clean burning two-stroke engine & auto major like Peugot, Aprila & other are directly installing these on their new models. It may not take long before this technology reaches India as Bajaj auto already has a tie-up with Orbital. This technology is not only restricted to two wheeler but Ford, BMW and other four wheeler auto majors have used this technology to manufacture cars powered with ASDI
Two stroke engine which much better performance than an equivalent four stroke engine
PRINCIPAL OF ASDI: -
Compressed air is used to assist the atomization of fuel injected directly into the combustion chamber, (typically after the exhaust port has closed) facilitating very fine control of air-fuel gradient around the spark plug. In addition, the air utilizes to scavenge and clean out the cylinder of bum gases. The Honda EXP-2& Bimota 500V uses the same technology. But it was Orbital modified Honda NSR- 125 that sparked this new trend. A new injection system and a compressor to supply the air for injection were the only equipment fitted. All the other parts were left intact.
ACTIVE RADICAL COMBUSTION
In simple terms, auto ignition bums up all the fuel in the cylinder. We currently associated with engine knock, a phenomenon that occurs when the fuel ignites before the spark plug fIres with the piston still on the up-stroke. This is caused when the temperature & pressure in a cylinder build up to a critical point and the air/fuel mixture explodes prematurely. Honda has tamed this pre-ignition on the EXP-2, which otherwise destroy a normal two stroke engine. Using premature combustion to more thoroughly bum the mixture is not a new idea- diesel don't have spark plug either. But it is for the fIrst time that this technology has been applied to 2-stroke petrol engine . The EXP-2 engine dose not use the spark plug above idle and below 40% throttle.
PRINCIPLE OF (A R C) : -
When fuel is brought to the right pressure & temperature; molecule breaks down into what are known as active radical molecules. These are highly unstable chemical compounds. Formed as an intermediate step in the actual combustion reaction. When hot exhaust gases remains in the cylinder the small percentage of active radical molecules combines with the incoming fuel charge & begins to auto ignite at a lower temperature than a pure petrol/air mixture.
TRAPPING VALVE
These type of exhaust valve system restrict the exhaust port at low r.p.m. and retract to uncover the exhaust port at high r.p.m.. They trap the unburned gases that’s scavenge out the burned gases from the combusion chamber before they can escape into the exhaust pipe. An engine equipe with sush a system delivers more power at low end and mid range without the use of an expansion chamber. This system is KAWASAKI KX250. In the EXP-2 as shown in cut way section of the exhaust port , the valve is raised and lowers the top of the exhaust port , their by decreasing and increasing the fuel mixture pressure in the cylinder as needed. By setting valve position base on the engine rpm and throttle position , the pressure required for auto ignition can be achived at exactly right timing , causing all fuel in the cylinder burn completely.
CONCLUSION
Thus by using these three technology, Honda EXP-2 produces 54 Hp and a 65N-m torqe making it one of the best motocross racing bike.This was proved at the Granda-Dakar rally , where it was adjusted first in both under 500-cc and 2-stroke class , 8 over all in Nevada rally and 7 over all Bajaj 1000. Honda will start the production of the worlds cleanest 2 stroke motor cycle by the end of this year.