19-11-2012, 11:56 AM
Gas Metal Arc Welding Metal Inert Gas
Gas Metal Arc Welding.ppt (Size: 787 KB / Downloads: 235)
Introduction
GMAW is defined as arc welding using a continuously fed consumable electrode and a shielding gas.
GMAW is also known as MIG (Metal Inert Gas).
Produces high-quality welds
Yields high productivity
Advantages
Large gaps filled or bridged easily
Welding can be done in all positions
No slag removal required
High welding speeds
High weld quality
Less distortion of work piece
Types of Metal Transfer
The basic GMAW process includes three distinctive process techniques:
Short Circuit (Short Arc)
Globular Transfer
Spray Arc Transfer
Short Circuit (Short Arc)
Operates at low voltages and welding current
Small fast-freezing weld puddle obtained
Useful in joining thin materials in any position, as well as thick materials in vertical and overhead positions
Metal transfer occurs when an electrical short circuit is established
Globular Transfer
Welding current and wire speed are increased above maximum for short arc
Droplets of metal have a greater diameter than the wire being used
Spatter present
Welding is most effectively done in the flat position when using globular transfer
Spray Arc Transfer
Occurs when the current and voltage settings are increased higher than that used for Globular Transfer
Used on thick sections of base material, best suited for flat position due to large weld puddle
Spatter is minimal to none
Welding Torch & Accessories
The welding torch guides the wire and shielding gas to the weld zone.
Brings welding power to the wire also
Major components/parts of the torch are the contact tip, shielding gas nozzle, gas diffuser, and the wire conduit
Welding Control & Wire Feed Motor
Welding control & Wire feed motor are combined into one unit
Main function is to pull the wire from the spool and feed it to the arc
Controls wire feed speed and regulates the starting and stopping of wire feed
Wire feed speed controls Amperage
Power Source
Almost all GMAW is done with reverse polarity also known as DCEP
Positive (+) lead is connected to the torch
Negative (-) lead is connected to the work piece
Provides a relatively consistent voltage to the arc
Arc Voltage is the voltage between the end of the wire and the work piece