17-01-2014, 02:48 PM
TESTS ON AGGREGATES
AIM
To determine the particle size distribution of fine and coarse
aggregates by sieving as per IS: 2386 (Part I) - 1963.
PRINCIPLE
By passing the sample downward through a series of standard
sieves, each of decreasing size openings, the aggregates are
separated into several groups, each of which contains aggregates
in a particular size range.
PROCEDURE
i)
The test sample is dried to a constant weight at a
o
temperature of 110 + 5 C and weighed.
ii) The sample is sieved by using a set of IS Sieves.
iii) On completion of sieving, the material on each sieve is
weighed.
iv) Cumulative weight passing through each sieve is calculated
as a percentage of the total sample weight.
v) Fineness modulus is obtained by adding cumulative
percentage of aggregates retained on each sieve and dividing
the sum by 100.
REPORTING OF RESULTS
The results should be calculated and reported as:
i) the cumulative percentage by weight of the total sample
ii) the percentage by weight of the total sample passing
through one sieve and retained on the next smaller sieve, to
the nearest 0.1 percent.