19-10-2012, 04:12 PM
modern Formula
modern Formula .doc (Size: 759.5 KB / Downloads: 33)
INTRODUCTION:
A modern Formula One car is a single-seat, open cockpit, open-wheel racing car with substantial front and rear wings, and an engine positioned behind the driver. The regulations governing the cars are unique to the championship. The Formula One regulations specify that cars must be constructed by the racing teams themselves, though the design and manufacture can be outsourced.
HISTORY:
Main article: History of Formula One
The Formula One series originated with the European Grand Prix Motor Racing (q.v. for pre-1947 history) of the 1920s and 1930s. The "formula" is a set of rules which all participants' cars must meet. Formula one was a new formula agreed after World War II during 1946, with the first no championship races being held that year. A number of Grand Prix racing organisations had laid out rules for a World Championship before the war, but due to the suspension of racing during the conflict, the World Drivers' Championship was not formalised until 1947. The first world championship race was held at Silverstone, United Kingdom in 1950. A championship for constructors followed in 1958. National championships existed in South Africa and the UK in the 1960s and 1970s. No championship Formula One events were held for many years but, due to the increasing cost of competition, the last of these occurred in 1983.
ENGINES & GEARBOX:
The 2006 Formula One season saw the Fédération Internationale de l'Automobile (FIA) introduce the current engine formula, which mandated cars to be powered by 2.4-litre naturally aspirated engines in the V8 engine configuration, with no more than four valves per cylinder. Further technical restrictions, such as a ban on variable intake trumpets, have also been introduced with the new 2.4 L V8 formula to prevent the teams from achieving higher RPM and horsepower too quickly. The 2009 season limited engines to 18,000 rpm, in order to improve engine reliability and cut costs.
For a decade F1 cars had run with 3.0-litre naturally aspirated V10 engines; however, development had led to these engines producing between 980 and 1,000 hp (730 and 750 kW), and reaching top speeds of 370 km/h (230 mph) on the Monza circuit.] Teams started using exotic alloys in the late 1990s, leading to the FIA banning the use of exotic materials in engine construction, and only aluminium and iron alloys were allowed for the pistons, cylinders, connecting rods, and crankshafts. The FIA has continually enforced material and design restrictions to limit power, otherwise the 3.0 L V10 engines would easily have exceeded 22,000 rpm[citation needed] and well over 1,000 hp (745 kW)[citation needed]. Even with the restrictions the V10s in the 2005 season were reputed to develop 980 hp (730 kW), which were reaching power levels not seen since the ban on turbo-charged engines in 1989.
The lesser funded teams (the former Minardi team spends less than 50 million, while Ferrari spent hundreds of millions of euros a year developing their car) had the option of keeping the current V10 for another season, but with a rev limiter to keep them from being competitive with the most powerful V8 engines. The only team to take this option was the Toro Rosso team, which was the reformed and regrouped Minardi.
The engines produce over 100,000 BTU/min (1,750 kW)[citation needed] of heat which is dissipated via radiators and the exhaust, which can reach temperatures over 1,000 °C (1,830 °F).[citation needed] They consume around 450 l (15.9 ft3) of air persecond.Race fuel consumption rate is normally around 75 l/100 km travelled (3.1 US mpg, 3.8 UK mpg, 1.3 km/l).
Nonetheless a Formula One engine is over 20% more efficient at turning fuel into power than most small commuter cars, considering their craftsmanship [citation needed].
All cars have the engine located between the driver and the rear axle. The engines are a stressed member in most cars, meaning that the engine is part of the structural support framework; being bolted to the cockpit at the front end, and transmission and rear suspension at the back end.
In the 2004 championship, engines were required to last a full race weekend. For the 2005 championship, they were required to last two full race weekends and if a team changes an engine between the two races, they incur a penalty of 10 grid positions. In 2007, this rule was altered slightly and an engine only had to last for Saturday and Sunday running. This was to promote Friday running. In the 2008 season, engines were required to last two full race weekends; the same regulation as the 2006 season. However for the 2009 season, each driver is allowed to use a maximum of 8 engines over the season, meaning that a couple of engines have to last three race weekends. This method of limiting engine costs also increases the importance of tactics, since the teams have to choose which races to have a new or an already-used engine.