Seminar Topics & Project Ideas On Computer Science Electronics Electrical Mechanical Engineering Civil MBA Medicine Nursing Science Physics Mathematics Chemistry ppt pdf doc presentation downloads and Abstract

Full Version: RADIOTRONIX Embedded Wireless Modules
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
RADIOTRONIX Embedded Wireless Modules

[attachment=24139]

EWD-900-HDTC MODULE (DATA)

The EWD-900-HDTC is an embedded wireless module based on the CC1000 transceiver from ChipCon. It can operate in
the 902-928 MHz band for the US and the 868-870 MHz band for Europe. It is a good choice for short range applications
where size is a consideration. An on-board EEPROM stores calibration information and a unique 48-bit MAC address.

EWM-900-FDTC MODULE (AUDIO/DATA)

The EWM-900-FDTC is based on the Numa Technologies NT2904 full-duplex transceiver. It is designed
to transmit and receive audio simultaneously, making it useful in applications such as wireless intercoms
or an application that requires wireless audio. The module operates in the unlicensed 902-928 MHz band.
Modules operate in pairs made up of a base station and a hand set (labeled –BS and –HS respectively).

REMOTE CONTROL MODULES

RCT Series Transmitters
The RCT series of remote control OOK transmitter modules from Radiotronix are the smallest, lowest cost
transmitter modules available. They are very easy to apply, just connect a data source, antenna, and power.
RCT transmitters are compatible with our RP and HP series receivers. These modules operate from 2-12V.
RCR-RP Series Receivers
The RCR-RP series of remote control receiver modules from Radiotronix allow the designer to create a very
low cost, wireless link capable of operation at up to 300 feet. The RP modules are based on a super-regenerative
receiver architecture, allowing them to work with virtually any AM/ASK/OOK transmitter available, including SAW
and LC based transmitters. These modules operate at 5V.
RCR-HP Series Receivers
The RCR-HP series of remote control receiver modules from Radiotronix offer better performance than the RP
series. The receiver is based on a super-heterodyne architecture, making the receiver much more immune to
outside interference. When coupled with our RCT transmitters, a very simple RF link is formed that is capable of
operation over distances of up to 1000 feet. These modules are available in 3V and 5V versions.