17-11-2012, 12:08 PM
Monopole antenna
A monopole antenna is a class of radio antenna consisting of a straight rod-shaped conductor, often mounted perpendicularly over some type of conductive surface, called a ground plane. The driving signal from the transmitter is applied, or for receiving antennas the output voltage is taken, between the lower end of the monopole and the ground plane. One side of the antenna feedline is attached to the lower end of the monopole, and the other side is attached to the ground plane, which is often the Earth. This contrasts with a dipole antenna which consists of two identical rod conductors, with the signal from the transmitter applied between the two halves of the antenna. Common types of monopole antenna are the whip, rubber ducky, helical, random wire, mast radiator, and ground plane antennas.
Radiation pattern
Like a dipole antenna, a monopole has an omnidirectional radiation pattern. That is it radiates equal power in all azimuthal directions perpendicular to the antenna, but the radiated power varies with elevation angle, with the radiation dropping off to zero at the zenith, on the antenna axis. It radiates vertically polarized radio waves. Certain types of monopole antennas, e.g. some helical antennas, can radiate circularly polarized waves.
A monopole can be visualized as being formed by replacing one half of a vertical dipole antenna with a ground plane at right-angles to the remaining half. If the ground plane is large enough, the radio waves reflected from the ground plane will seem to come from an image antenna forming the missing half of the dipole, which adds to the direct radiation to form a dipole radiation pattern. So the pattern of a monopole with a perfectly conducting, infinite ground plane is identical to the top half of a dipole pattern, with its maximum radiation in the horizontal direction, perpendicular to the antenna. Because it radiates only into the space above the ground plane, or half the space of a dipole antenna, a monopole antenna will have a gain of twice (3 dBi over) the gain of a similar dipole antenna, and a radiation resistance half that of a dipole. Thus a quarter-wave monopole, the most common type, will have a gain of 5.19 dBi and a radiation resistance of about 36.8 ohms if it is mounted above a good ground plane.[1]
The general effect of electrically small ground planes, as well as imperfectly conducting earth grounds, is to tilt the direction of maximum radiation up to higher elevation angles.[2]
Types
The ground plane used with a monopole may be the actual earth; in this case the antenna is mounted on the ground and one side of the feedline is connected to an earth ground at the base of the antenna. This design is used for the mast radiator antennas employed in radio broadcasting at low frequencies, as well as other low frequency antennas such as the T-antenna and umbrella antenna. At VHF and UHF frequencies the size of the ground plane needed is smaller, so artificial ground planes are used to allow the antenna to be mounted above the ground. A common type of monopole antenna at these frequencies consists of a quarter-wave whip antenna with a ground plane consisting of several wires or rods radiating horizontally from its base; this is called a ground-plane antenna. At gigahertz frequencies the metal surface of a car roof or airplane body makes a good ground plane, so car cell phone antennas consist of short whips mounted on the roof, and aircraft communication antennas frequently consist of a short conductor in an aerodynamic fairing projecting from the fuselage; this is called a blade antenna.[1] The quarter-wave whip and "Rubber Ducky" antennas used with handheld radios such as walkie-talkies and cell phones are also monopole antennas.
Monopole broadcasting antennas
When used for radio broadcasting, the radio frequency power from the broadcasting transmitter is fed across the base insulator between the tower and a ground system. The ideal ground system for AM broadcasters comprises at least 120 buried copper or phosphor bronze radial wires at least one-quarter wavelength long and a ground-screen in the immediate vicinity of the tower. All the ground system components are bonded together, usually by welding, brazing or using coin silver solder to help reduce corrosion. Monopole antennas that use guy-wires for support are called masts in some countries. In the United States, the term “mast” is generally used to describe a pipe supporting a smaller antenna, so both self-supporting and guy-wire supported radio antennas are simply called monopoles if they stand alone. If multiple monopole antennas are used in order to control the direction of Radio Frequency (RF) propagation, they are called directional antenna arrays.
A monopole antenna is a class of radio antenna consisting of a straight rod-shaped conductor, often mounted perpendicularly over some type of conductive surface, called a ground plane. The driving signal from the transmitter is applied, or for receiving antennas the output voltage is taken, between the lower end of the monopole and the ground plane. One side of the antenna feedline is attached to the lower end of the monopole, and the other side is attached to the ground plane, which is often the Earth. This contrasts with a dipole antenna which consists of two identical rod conductors, with the signal from the transmitter applied between the two halves of the antenna. Common types of monopole antenna are the whip, rubber ducky, helical, random wire, mast radiator, and ground plane antennas.
Radiation pattern
Like a dipole antenna, a monopole has an omnidirectional radiation pattern. That is it radiates equal power in all azimuthal directions perpendicular to the antenna, but the radiated power varies with elevation angle, with the radiation dropping off to zero at the zenith, on the antenna axis. It radiates vertically polarized radio waves. Certain types of monopole antennas, e.g. some helical antennas, can radiate circularly polarized waves.
A monopole can be visualized as being formed by replacing one half of a vertical dipole antenna with a ground plane at right-angles to the remaining half. If the ground plane is large enough, the radio waves reflected from the ground plane will seem to come from an image antenna forming the missing half of the dipole, which adds to the direct radiation to form a dipole radiation pattern. So the pattern of a monopole with a perfectly conducting, infinite ground plane is identical to the top half of a dipole pattern, with its maximum radiation in the horizontal direction, perpendicular to the antenna. Because it radiates only into the space above the ground plane, or half the space of a dipole antenna, a monopole antenna will have a gain of twice (3 dBi over) the gain of a similar dipole antenna, and a radiation resistance half that of a dipole. Thus a quarter-wave monopole, the most common type, will have a gain of 5.19 dBi and a radiation resistance of about 36.8 ohms if it is mounted above a good ground plane.[1]
The general effect of electrically small ground planes, as well as imperfectly conducting earth grounds, is to tilt the direction of maximum radiation up to higher elevation angles.[2]
Types
The ground plane used with a monopole may be the actual earth; in this case the antenna is mounted on the ground and one side of the feedline is connected to an earth ground at the base of the antenna. This design is used for the mast radiator antennas employed in radio broadcasting at low frequencies, as well as other low frequency antennas such as the T-antenna and umbrella antenna. At VHF and UHF frequencies the size of the ground plane needed is smaller, so artificial ground planes are used to allow the antenna to be mounted above the ground. A common type of monopole antenna at these frequencies consists of a quarter-wave whip antenna with a ground plane consisting of several wires or rods radiating horizontally from its base; this is called a ground-plane antenna. At gigahertz frequencies the metal surface of a car roof or airplane body makes a good ground plane, so car cell phone antennas consist of short whips mounted on the roof, and aircraft communication antennas frequently consist of a short conductor in an aerodynamic fairing projecting from the fuselage; this is called a blade antenna.[1] The quarter-wave whip and "Rubber Ducky" antennas used with handheld radios such as walkie-talkies and cell phones are also monopole antennas.
Monopole broadcasting antennas
When used for radio broadcasting, the radio frequency power from the broadcasting transmitter is fed across the base insulator between the tower and a ground system. The ideal ground system for AM broadcasters comprises at least 120 buried copper or phosphor bronze radial wires at least one-quarter wavelength long and a ground-screen in the immediate vicinity of the tower. All the ground system components are bonded together, usually by welding, brazing or using coin silver solder to help reduce corrosion. Monopole antennas that use guy-wires for support are called masts in some countries. In the United States, the term “mast” is generally used to describe a pipe supporting a smaller antenna, so both self-supporting and guy-wire supported radio antennas are simply called monopoles if they stand alone. If multiple monopole antennas are used in order to control the direction of Radio Frequency (RF) propagation, they are called directional antenna arrays.