26-02-2011, 09:55 AM
biometric voting.doc (Size: 190.5 KB / Downloads: 159)
Biometric Voting system
ABSTRACT
It has always been an arduous task for the election commission to conduct free and fair polls in our country, the largest democracy in the world. Crores of rupees have been spent on this to make sure that the elections are riot free. But, now- a -days it has become common for some forces to indulge in rigging which may eventually lead to a result contrary to the actual verdict given by the people.
This paper aims to present a new voting system employing biometrics in order to avoid rigging and to enhance the accuracy and speed of the process. The system uses thumb impression for voter identification as we know that the thumb impression of every human being has a unique pattern. Thus it would have an edge over the present day voting systems.
As a pre-poll procedure, a database consisting of the thumb impressions of all the eligible voters in a constituency is created. During elections, the thumb impression of a voter is entered as input to the system. This is then compared with the available records in the database. If the particular pattern matches with any one in the available record, access to cast a vote is granted. But in case the pattern doesn’t match with the records of the database or in case of repetition, access to cast a vote is denied or the vote gets rejected. Also the police station nearby to the election poll booth is informed about the identity of the imposter. All the voting machines are connected in a network, through which data transfer takes place to the main host. The result is instantaneous and counting is done finally at the main host itself. The overall cost for conducting elections gets reduced and so does the maintenance cost of the systems.
INTRODUCTION
Biometrics is the term given to the use of biological traits or behavioral characteristics to identify an individual. The traits may be fingerprints, hand geometry, facial geometry, retina patterns, voice recognition, and handwriting recognition.
In this paper we have used thumb impression for the purpose of voter identification or authentication. As the thumb impression of every individual is unique, it helps in maximizing the accuracy. A database is created containing the thumb impressions of all the voters in the constituency. Illegal votes and repetition of votes is checked for in this system. Hence if this system is employed theelections would be fair and free from rigging. Thanks to this system that conducting elections would no longer be a tedious and expensive job.
DESIGN
The design of the system consists of the following important parameters
1. Scanning- using DSP Processor
2. Searching- based on the principle of preloaded database
The only pre-requisite for the use of this finger print scanner is a personal identification card. We hope that this system proves to be efficient and enables the people to be smarter in choosing their leaders.
SUMMARY OF DESIGN
The main aim in designing this product is to provide the concept of the personal identity for each individual. This is extended to a special case of electronic voting machine concept. The summary of the design can be briefly explained diagrammatically as follows.
As a pre-poll procedure the finger prints of all the voters are collected and stored in a database initially at time of distributing voting cards. At the time of voting, the option of the voter is taken along with the finger print. The finger print taken by the scanner is sent to the
DSP chip through an in-built A/D converter. The processed image is transferred to hard disk with biasing of SDRAM.
The option entered by the voter is transferred to chip through DEMUX and is stored in the memory. If the transferred image is matched with any of the records in the data base, then the interrupt is given by the HARD DISK to DSP chip. Then the option is considered in the count. After the acquisition of the count this is transmitted to the HOST computer or central server using telephone lines .
As the count of each party is transmitted to the HOST from all the VOTING MACHINES present in the constituency, the HOST will add parallel count of particular party and makes the final count of each party in ascending order. The final count is transferred to the main HOST (head quarters) using either telephone lines or radio waves.