13-05-2011, 03:31 PM
This simple automatic emergencylight has the followingadvantages over conventionalemergency lights:1. The charging circuit stops automaticallywhen the battery is fullycharged. So you can leave the emergencylight connected to AC mainsovernight without any fear.2. Emergency light automaticallyturns on when mains fails. So youdon’t need a torch to locate it.3. When mains power is available,emergency light automatically turnsoff.The circuit can be divided into inverterand charger sections. The invertersection is built around timerNE555, while the charger section isbuilt around 3-terminal adjustableregulator LM317.In the inverter section, NE555 iswired as an astable multivibrator thatproduces a 15kHz squarewave. Outputpin 3 of IC 555 is connected to theDarlington pair formed by transistorsSL100 (T1) and 2N3055 (T2) via resistorR4. The Darlington pair drives ferritetransformer X1 to light up thetubelight.For fabricating inverter transformerX1, use two EE ferrite cores (of25×13×8mm size each) along with plasticformer. Wind 10 turns of 22 SWGon primary and 500 turns of 34 SWGwire on secondary using some insulationbetween the primary and secondary.To connect the tubelight to ferritetransformer X1, first short both terminalsof each side of the tubelightand then connect to the secondary ofX1. (You can also use a Darlington pairof transistors BC547 and 2N6292 for a6W tubelight with the same transformer.)When mains power is available, resetpin 4 of IC 555 is grounded viatransistor T4. Thus, IC1 (NE555) doesnot produce squarewave and emergencylight turns off in the presenceof mains supply.When mains fails, transistor T4does not conduct and reset pin 4 getspositive supply though resistor R3. IC1(NE555) starts producing squarewave and tubelight turns on viaferrite transformer X1.In the charger section, inputAC mains is stepped down bytransformer X2 to deliver 9V-0-9V AC at 500 mA. Diodes D1and D2 rectify the output of thetransformer. Capacitors C3 andC4 act as filters to eliminateripples. The unregulated DCvoltage is fed to IC LM317 (IC2).By adjusting preset VR1, theoutput voltage can be adjustedto deliver the charging voltage.When the battery getscharged above 6.8V, zener diodeZD1 conducts and regulator IC2stops delivering the chargingvoltage.Assemble the circuit on ageneral-purpose PCB and enclosein a cabinet with enoughspace for the battery andswitches. Connect a 230V ACpower plug to feed chargingvoltage to the battery andmake a 20W tube outlet in thecabinet to switch on thetubelight
DOWNLOAD FULL REPORT
http://pecworld.zxqAssets/SOURCE/PDF_fun..._Feb07.pdf
DOWNLOAD FULL REPORT
http://pecworld.zxqAssets/SOURCE/PDF_fun..._Feb07.pdf