29-08-2014, 02:17 PM
For completion of project I took help of the following shops :
1.Mock up cell
2. Proto machine shop
3.Proto shop
4. Vendor audit quality
While making my project I followed the following method of inspection :
1. Visual inspection :-Basic step for inspection of component is visual inspection. In this method of inspection we check the component visually from the given drawing i.e. number of holes, number of cuts etc. Avisual comparisonis to compare two or more things by eye. This might be done by placing them side by side; by overlaying them; by alternating an image or by presenting each image to a separate eye. Such comparisons are the first stage in a child's development of an understanding of geometry and measurement, before they move to an understanding of measuring devices such as a ruler.
2. Measurement with instrument :- In this type of measurement we use following instrujments
2.1 Vernier caliper
2.2 Micrometer
2.3 Hieght gauge
2.4 Ruler
2.5 Measuring tape
2.6 Bore
3.Measurement wiht 1:1 drawing :- This method is used for very complex shapes which become difficult in measurement with the helpl of above instruments. In this method we measure the dimension of component with the help of 1:1 drawing sheets. For measurement we placed the component on drawing sheet, then see whether the total part super impose or not. If total part is super imposable then it is corrected otherwise it is further goes for modification.
For making of my project Mr. Rajan Sharma guided me in a very good manner from his knowledge and experience. He provided me his full support in order to complete my project.