17-10-2014, 12:48 PM
Abstracts: The assignment undertaken by me was very interesting.It consisted study of several drawings, assembly drawing of fuel injector. The analysis carried out of fuel injector components.Majorly the failure occurrence in two components viz 1)Injector Body 2)Nozzle The analysis was carried out using software like Pro/Engineering 5.0.Ansys 14.0. The maximum stresses induced in the components could be easily detected. Maximum possibility/chances of failure of components could be studied after applying various constraints parameters. There were two probability which were 1)Changing Material Dimensions 2)Changing the Material The later was selected as a result of which the failure could be eliminated/restricted.