18-06-2011, 02:56 PM
PROJECT.docx (Size: 210.25 KB / Downloads: 234)
INTRODUCTION
Rainwater harvesting is the accumulating and storing, of rainwater for reuse, before it reaches the aquifer. It has been used to provide drinking water, water for livestock, water for irrigation, as well as other typical uses given to water. Rainwater collected from the roofs of houses, tents and local institutions, can make an important contribution to the availability of drinking water. Water collected from the ground, sometimes from areas which are especially prepared for this purpose, is called Stormwater harvesting. In some cases, rainwater may be the only available, or economical, water source. Rainwater harvesting systems can be simple to construct from inexpensive local materials, and are potentially successful in most habitable locations. Roof rainwater can be of good quality and may not require treatment before consumption. Although some rooftop materials may produce rainwater that is harmful to human health, it can be useful in flushing toilets, washing clothes, watering the garden and washing cars; these uses alone halve the amount of water used by a typical home. Household rainfall catchment systems are appropriate in areas with an average rainfall greater than 200 mm (7.9 in) per year, and no other accessible water sources (Skinner and Cotton, 1992). Overflow from rainwater harvesting tank systems can be used to refill aquifers in a process called groundwater recharge, though this is a related process, it must not be confused with Rainwater harvesting.
Basic configuration
Rainwater harvesting systems channel rainwater that falls on to a roof into storage via a system of gutters and pipes. The first flush of rainwater after a dry season should be allowed to run to waste as it will be contaminated with dust, bird droppings etc. Roof gutters should have sufficient incline to avoid standing water. They must be strong enough, and large enough to carry peak flows. Storage tanks should be covered to prevent mosquito breeding and to reduce evaporation losses, contamination and algal growth. Rainwater harvesting systems require regular maintenance and cleaning to keep the system hygienic.
Subsurface dyke
A subsurface dyke is built in an aquifer to obstruct the natural flow of groundwater, thereby raising the groundwater level and increasing the amount of water stored in the aquifer.
The subsurface dyke at Krishi Vigyan Kendra, Kannur under Kerala Agricultural University with the support of ICAR, has become an effective method for ground water conservation by means of rain water harvesting technologies. The sub-surface dyke has demonstrated that it is a feasible method for conserving and exploiting the groundwater resources of the Kerala state of India. The dyke is now the largest rainwater harvesting system in that region.
Groundwater recharge
Rainwater may also be used for groundwater recharge, where the runoff on the ground is collected and allowed to be absorbed, adding to the groundwater. In the US, rooftop rainwater is collected and stored in sump.
Advantages in urban areas
Rainwater harvesting can (a) assure an independent water supply during water restrictions, that is though somewhat dependent on end use and maintenance, (b)usually of acceptable quality for household needs and © renewable at acceptable volumes despite forecast climate change (CSIRO, 2003). It produces beneficial externalities by reducing peak storm water runoff and processing costs. In municipalities with combined sewer systems, reducing storm runoff is especially important, because excess runoff during heavy storms leads to the discharge of raw sewage from outfalls when treatment plant capacity cannot handle the combined flow. RH systems are simple to install and operate. Running costs are negligible, and they provide water at the point of consumption. We are consuming this water for our basic needs.