10-11-2014, 12:49 PM
Abstracts: This application report describes a plotting a drawing system based on Auto-cad software file with ATMEGA-328 28Pin Flash-Based, 8-Bit CMOS Microcontrollers with nano Watt Technology microcontroller. This application report describes a significant property of pen-plotter drawings is there on a physically / mechanically drawn line. It is the pen, which is drawn with help of the stepper motor and servo motor. This motor is controlled by controller. In the pc there is PCB Design software which is used to generate any drawing. The pcb design software generates the file (.text) this file gives the different X-Y values which is used for different direction or angle of the pen to generate the line. And Z direction is used to pick up the pen to other direction. The visual studio software is used to fetch the (.text) file and convert into appropriate file which can be read by the controller and it controls the all motors to create the desire picture in the software. There are two stepper motors which are used for X-Y axis. And servo motor is used for the Z axis to pick up the pen to other direction. There is RF module (sensor) is used to communicate between PC and controller side part. RF sensor is used for the data (drawing) which can be generated in visual studio software to give to the controller side part.