20-04-2012, 05:13 PM
Summer Internship InMahindra & Mahindra
Summer Internship.pptx (Size: 135.59 KB / Downloads: 175)
MAIN ACTIVITIES :
Feasibility study / Budgeting & sanctions for any new Product / Project.
Process design and Productionization of the Product & Projects.
Plant & Shop Layouts Management.
Facilities, Resource & Equipment Planning & Arrangement
Tooling Design and Management
Work Measurement, Line Balancing & Manpower Planning
Productivity Management
New Product introduction through APQP / MPDS route
SAP and Process BOM Management
KAIZEN Activities & Improvements
INTRODUCTION TO BOLERO SHED
BOLERO shed is a place where assembly of BOLERO 4-wheeler is done. This shed consist of:
TRIM LINE
FACIA LINE
CHASSIS LINE
ENGINE LINE
MAIN LINE
TRIM LINE:
Vehicle Body comes from Paint Shop & goes to Trim Line where various operations on body are carried out like Floor Carpet Fitment, Battery Fitment, Trim Pads Fitment, Body Doors Fitment, AC Fitment, Instrument Panel Fitment, Tapping of seat holes, Car Roof Covering, Fitment of various Harnesses for Vehicle’s Electrical Functions, etc.
FACIA LINE:
Vehicle’s Facia after getting separated from Body goes to Facia Line where various Operations are carried out on Facia like AC Condenser fitment, Air Deflector Fitment, Reservoir Fitment, Modulator Fitment, Euro Tubes Fitment, Headlamp Fitment, Side Indicator Fitment, etc
CHASSIS LINE:
Vehicle’s Chassis enters the chassis line after inspection and then various operations like Rear & Front Axle Fitment, Front & Rear Shock Absorber Fitment (Coil Spring & Leaf Spring), Steering Gearbox Fitment, Stabilizer Bar Fitment & Fuel Tank Fitment on Chassis are carried out.
ENGINE LINE:
In Engine Line, Engine wiring Harness is fitted to the Engine along with Speedo Sensor. Bell Housing attached to a Gear Box is also coupled to an Engine & Clutch Plate too is fitted. Then Starter Motor and Power Steering Pump & Reservoir are also fitted.